Note:The sensing distance of Oil-resistive Retro-reflective models is different from that of standard Retro-reflective models.
*1.The Reflector is sold separately. Select the Reflector model most suited to the application.
*2.The
sensing distance specified is possible when the E39-R1S used. Values in
parentheses indicate the minimum required distance between the Sensor
and Reflector.
*3.Models
with a 0.5-m cable are available as a standard feature for products
marked *3. When ordering, specify the cable length by adding the code
"0.5M” to the model number (e.g., E3Z-T61 0.5M).
*4.Pre-wired
M12 Connectors are available for models in the table marked *4. These
models have the -M1J suffix. (Example: E3Z-T61-M1J)
*5.Press-fit e-CON Pre-wired Connectors are available with 0.3-m, 0.5-m, and 2-m cables for models in the table marked *5.
The
model number is E3Z-[]6[]-ECON. The connector is the E39-ECON[]M with a
2-m or 5-m cable and a connector on one end or the E39-ECONW[]M with a
0.5-m to 2-m cable (length increases in 0.1-m increments) and
connectors at both ends.
This e-CON specification is rapidly becoming the standard for FA equipment and connector manufacturers.
*6.Clamp-type
e-CON Pre-wired Connectors are available with a 2-m cable. The suffix
for these models is -ECON-C. (Example: E3Z-T61-ECON-C 2 M) The
connectors are E-39-ECON []M with a 2-m or 5-m cable and a connector on
one end or the E39-ECONW[]M with a 0.5-m to 2-m cable (length increases
in 0.1-m increments) and connectors at both ends. This e-CON
specification is rapidly becoming the standard for FA equipment and
connector manufacturers.
